Hostname: page-component-54dcc4c588-64p75 Total loading time: 0 Render date: 2025-10-06T12:40:36.320Z Has data issue: false hasContentIssue false
  • English
  • Français

Direct Ink Jet Printing of Alumina Components

Published online by Cambridge University Press:  17 March 2011

C. Ainsley ,
N. Reis  and
B. Derby
C. Ainsley
Affiliation:
Manchester Materials Science Centre, UMIST, Grosvenor St, Manchester M1 7HS, U.K.
N. Reis
Affiliation:
Manchester Materials Science Centre, UMIST, Grosvenor St, Manchester M1 7HS, U.K.
B. Derby
Affiliation:
Manchester Materials Science Centre, UMIST, Grosvenor St, Manchester M1 7HS, U.K.
Get access

Abstract

Alumina slurries containing up to 40% by volume ceramic particles suspended in alkane waxes have been developed with viscosity sufficiently low to allow direct ink-jet printing. Components fabricated by printing have been dewaxed, sintered and shrinkage and density measured. Small differences in shrinkage have been measured parallel and perpendicular to the droplet motion but these are within experimental scatter. The manufacturing process appears to generate bands of slightly larger grain size material at the interface between deposited layers.

Information

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 698: Symposia Q/EE Electroative Polymers and Rapid Prototyping , 2001 , Q4.4.1
Copyright
Copyright © Materials Research Society 2002

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable

References

REFERENCES

1. Sachs, E., Cima, M., William, P., Brancazio, D., and Cornie, J., J. Eng. Ind. -Trans ASME 114, 481 (1992).Google Scholar
2. Blazdell, P. F. and Evans, J. R. G., J. Mater. Proc. Tech. 99, 94 (2000).Google Scholar
3. Slade, C. E. and Evans, J. R. G., J. Mater. Sci. Lett. 17, 1669 (1998).Google Scholar
4. Xiang, Q. F., Evans, J. R. G., Edirisinghe, M. J., and Blazdell, P. F., Proc. Inst. Mech. Eng. B- J. Eng. Manuf. 211, 211 (1997).Google Scholar
5. Reis, N. and Derby, B., in Solid Freeform and Additive Fabrication – 2000, edited by. Danforth, S.C., Dimos, D. and Prinz, F.B., (Mater. Res. Soc. Symp. Proc. 625, Pittsburgh, PA, 2000) pp. 117–122.Google Scholar
6. Seerden, K. A. M., Reis, N., Evans, J. R. G., Grant, P. S., Halloran, J. W., and Derby, B., J. Amer. Ceram. Soc., 84, 2514 (2001).Google Scholar
7. FARRIS, R.J.,. Trans. Soc. Rheol. 2, 281–301 (1968)Google Scholar
8. Krieger, I.M. and Eguiluz, M.. Trans. Soc. Rheol. 20, 29–45 (1976).Google Scholar