Hostname: page-component-54dcc4c588-smtgx Total loading time: 0 Render date: 2025-10-10T05:16:44.039Z Has data issue: false hasContentIssue false
  • English
  • Français

Deformation Properties of a Lead-Tin (95–5) Solder

Published online by Cambridge University Press:  25 February 2011

D. Stone ,
H. Wilson ,
R. Subrahmanyan  and
Che-Yu Li
D. Stone
Affiliation:
Department of Materials Science and Engineering Cornell University, Ithaca, NY 14853
H. Wilson
Affiliation:
Department of Materials Science and Engineering Cornell University, Ithaca, NY 14853
R. Subrahmanyan
Affiliation:
Department of Materials Science and Engineering Cornell University, Ithaca, NY 14853
Che-Yu Li
Affiliation:
Department of Materials Science and Engineering Cornell University, Ithaca, NY 14853
Get access

Abstract

Consecutive load relaxation tests are performed on a 95 Pb-5 Sn specimen near room temperature, then at 69 ° C and 1°C. The initial relaxation runs at room temperature show evidence of static recovery, which diminishes after a number of load relaxations have been performed. Evidence of grain boundary sliding is also found. The specimen hardens slowly at 69°C, as manifested by successive load relaxation data falling at lower strain rates. At 1°C, the material slowly softens. These temperature effects are believed to result from a dislocation-solute interaction involving tin atoms in the lead matrix.

Information

Type
Articles
Information
MRS Online Proceedings Library (OPL) , Volume 72: Symposium G – Electronic Packaging Materials Science II , 1986 , 175
Copyright
Copyright © Materials Research Society 1986

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable

References

1. Stone, D., Hannula, S.-P., and Li, C.-Y., Proc. 35th ECC, IEEE, New York, NY (1985), pp. 46–51.Google Scholar
2. Lee, D. and Hart, E.W., Metall. Trans. A, vol.2 (1971), pp. 1245–1248.CrossRefGoogle Scholar
3. Hart, E.W., Acta Metall., vol.15 (1967), pp. 1545–1549.Google Scholar
4. Ghahremani, F., Int. J. Solid Structures, vol.16 (1980), pp. 825–845.CrossRefGoogle Scholar
5. Hart, E.W., J. Engr. Mat. and Tech., vol.98 (1976), pp. 193–202.CrossRefGoogle Scholar
6. Hannula, S.-P., Korhonen, M.A., and Li, C.-Y., Res Mechanica, vol.15, (1985), pp. 99–128.Google Scholar
7. Takeuchi, S. and Argon, A.S., Phil. Mag. A, vol.40, no. 1 (1979), pp. 65–75.CrossRefGoogle Scholar