No CrossRef data available.
Published online by Cambridge University Press: 24 July 2025
Wall cooling is a promising method in controlling compressible flows, including hypersonic shock wave turbulent boundary layer interaction (STBLI). Based on the verified DNS method, a 30-degree compression ramp is used to generate STBLI for Ma of 5 and wall to recovery temperature ratio ranging from 0.2 to 1.0. The results indicate that the separation zone decreases for cold wall conditions and quantitatively validate the wall-temperature-corrected interaction scaling theory in recent literature. The heat transfer results show that the wall cooling greatly influences the heat flux distribution and peak values in STBLI. The two-stage heat flux increase disappears for the cold wall, which corresponds to the reduced separation bubble. The local decrease of the recovery temperature is observed after the shock, which causes the negative heat flux minimum for near ‘adiabatic’ wall conditions and can be attributed to the acceleration of the near-wall supersonic fluid in the turning process. On the whole, the decrease of the wall temperature leads to the 24.3% decrease of the peak heat flux enhancement, and the underlying mechanism is the decrease of the near-wall turbulent aerodynamic heat dissipation enhancement for the wall cooling.